1/16/2023 0 Comments Casio tide graph manual![]() ![]() It takes approximately 20 to 30 minutes for the case of the watch to reach the actual surrounding temperature. To achieve a more accurate temperature measurement, remove the watch from your wrist, place it in a well ventilated location out of direct sunlight, and wipe all moisture from the case. Temperature measurements are affected by your body temperature (while you are wearing the watch), direct sunlight, and moisture.See “Temperature Sensor Calibration” for more information. You can calibrate the temperature sensor if you feel that the displayed temperature values are not correct.The display range of the thermometer screen is –10.0 ☌ to 60.0 ☌ (or 14.0 ☏ to 140.0 ☏).The thermometer screen displays temperature values in 0.1 ☌ units (or 0.2 ☏ units).See “To specify the temperature display unit” for more information. You can select either Celsius ( ☌) or Fahrenheit ( ☏) units for the thermometer screen.Measured temperature values are stored in memory for later recall when you need them. The watch also takes separate readings and stores them in memory for display in the temperature tendency graph, which can be viewed in the Timekeeping Mode. A reading is taken during each even-numbered minute, and the result of the last reading is displayed on the thermometer screen. This watch uses a temperature sensor to measure temperature. To return to the Timekeeping Mode, press C.The minute hand will be adjusted slightly to match the seconds when you exit the setting screen. ![]() It will also stop automatically after the time advances 12 hours or if an alarm (daily alarm, Hourly Time Signal, or countdown beeper) starts to sound. The hands will continue to advance for one 12-hour cycle or until you press any button to stop it. To lock high speed hands movement, hold down Dto start it and then press B to lock.Hold down D to advance the hands at high speed.Press Donce to advance the hands 20 seconds.Hold down Auntil the current digital time starts toįlash, which indicates the setting screen. In the Timekeeping Mode, press Cseven times toĢ. Perform the procedure below when the time indicated by the analog hands does not match the time of the digital display. Use D to switch between east longitude ( E)Ħ. You can specify a value from 0˚ to 180˚, in 1- degree units.Use D(+) and B (–) to change the setting. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |